QS - Print & Piece Fuse Lite

Directions for Use and Care

For paper or foundation piecing:

• If possible, set your printer’s paper feed settings to “Decorative or Heavy Paper.” If your printer does not have this setting, load only one sheet of Print & Piece at a time.
• Copy or print your favorite foundation or paper-piecing pattern directly onto Print & Piece stabilizer.
• Cover the numbered sections as directed with your favorite fabrics until the block is complete.
• Remove the stabilizer: once the stitching is complete, lightly dampen only the stitching lines with a wet sponge or cotton swab – the stabilizer tears away gently without distorting the stitches!
• You can alternately leave the stabilizer within the block completely. When the quilt is laundered, the watersoluble fibers will dissolve and the non-soluble fibers will leave behind a very subtle loft. Create a test block with this method before applying it to an entire quilt to make
  sure you are happy with the results!

For stabilizing decorative or satin stitches:

• Place one layer of Print & Piece directly under fabric and stitch.
• To remove the stabilizer, lightly dampen only the stitching with a sponge or cotton swab – the stabilizer will pull away without distorting delicate heirloom, satin or decorative stitches!

Washer and Dryer Safe

Cool water and low drying temperature recommended.

Press using a medium setting on your iron.

25 pieces 8½" x 11" printable sheets (21.59 cm x 27.9 cm)